Cattron Remtron 22R08A, User Manual

Page: 19 / 26

CommandPro
®
General Purpose & Safety Applications
User Manual
19
9M02-9028-A031-EN
Rev 4
6.6 Changing the Transmitter Identity Codes
Changing the ID Code requires use of a Cattron RAC16A Series Programmer. Refer to Figure 3 and Figure 4 for
your transmitter.
1. Confirm that the batteries are fresh (refer to the Transmitter Troubleshooting chart).
2.
On ‘A’ Series IP67 rated transmitters, remove the battery door and batteries before removing the back of
the transmitter.
3. Using the RAC16 Series Programmer, attach the programming plug to the 4-pin connector on the circuit
board. Verify that the ID Code is displayed.
4. Enter the new ID Code and press the PRG key.
5.
On ‘A’ Series IP67 rated transmitters, replace the battery door and batteries after replacing the back
panel. Verify the
battery cover “O” ring is properly seated. ‘A’ Series captive screws should be tightened
until snug, plus half a turn.
Refer
to the RAC16 Series User’s Manual for more detailed instructions.
6.7 24T09 Specifications
Item Detail
Operating frequency band 902
– 928 MHz
Channel spacing 300 KHz
Modulation Digital Frequency Modulation based on Manchester Code.
Contains 16-bit address plus 16- bit CRC check
Command functions Up to 9
Power, input
2 AA cell batteries (Alkaline recommended). Output power Meets FCC Part
15 requirements for license -free operation
Antenna Internal circuit board
Indicators Self-test LED indicator
Transmitter case dimensions
2.75" x 8.0" x 1.0" (IP67 rated ‘A’ version: 2.75" x 7.11" x 1.22" )
Transmitter weight
9 oz (IP67 rated ‘A’ version: 10.9 oz.), including Alkaline batteries
Ambient operating conditions -20º F to +160º F (-28º C to +71º C)
FCC ID # EGT814TX
Industry Canada Certification # 249 710 31887
6.8 24T09 Spare Parts List
Item Part Number
Spare Transmitter (complete) Use Model No./Serial No.
Shoulder strap 42C-0057
Leather Holster
620007 (IP67 rated ‘A’ version: 620023)
Clear, plastic protective pouch
620011 (IP67 rated ‘A’ version: 620025)
Case screws, 6-32 5/8 Phillips, stainless steel 500047
Case screws, captive, ‘A’ series transmitters
500132
Replacement Transmitter Label Use Model No./Serial No.