Cattron CattronControl CCM12, User Manual

Page: 24 / 25

CCM12 CANbus
User Manual
24
9M02-7717-A001-EN
Version 3.0
Appendix A: Error Codes
ERROR CODE ERROR ACTION
2 flashes TransKey cannot be read Make sure the TransKey is in place
3 flashes TransKey configuration
fault Verify TransKey configuration is coherent with the actual
hardware. Ex: RF module selected is not the same as the
one installed.
4 flashes Fault during voltage monitor
test Send to Cattron for repair
5 flashes Fault with the safety relays Send to Cattron for repair
6 flashes (not used)
7 flashes Fault with RF module Replace the RF module
8 flashes General system error Send to Cattron for repair
9 flashes Relay control voltage is too
low Send to Cattron for repair
10 flashes Hardware fault Send to Cattron for repair
11 flashes (not used)
12 flashes (not used)
13 flashes Slave CAN controller cross-
monitor error Make sure both master and slave CAN interfaces are
properly connected to the CAN bus
14 flashes
Master CAN controller
cross-monitor error Make sure both master and slave CAN interfaces are
properly connected to the CAN bus
Rotary switches invalid
setting Make sure switches SW1 to SW3 are set to valid positions