CANplus
TM
CP800
Control Panel Operation Manual
33
9M02-1000-A201-EN
Revision E
8.3 CANplus
TM
Customizer Software Suite and a USB Drive
to view the CP800 Import, Export, Configurations and Software Upgrade video.
The CP800 introduces the ability to import and export configurations using a USB drive, avoiding the need to
purchase and have onsite a CANplus
TM
Config Kit as well as the need to disconnect the panel from the engine.
The panel’s USB port can be accessed by simply removing the four front faceplate screws. The USB port
location, shown in the following figure, is protected by a water-tight rubber plug.
Install the USB drive in the panel’s USB port. The current configuration can be exported by going to the
System
→
Export Config.
menu. To import a new configuration, the menu access level must be at the Tech or Admin
level (see the
section). A new configuration is imported by going to the
System
→
Import Config.
menu. New configuration changes take effect immediately. Therefore, the engine should not be running when
importing a new configuration.
When finished with exporting or importing configurations, remove the USB drive, reinstall the protective water-
tight rubber plug, and secure the faceplate with the four screws.
