Protocol Analyzer Projects
Catalyst Enterprises, Inc.
23
Triggering Setup
The
Trigger-on
tab, allows the user to specify when the analyzer will complete a data
capture. Three trigger modes are available: The default
Don’t care (Snapshot),
Manual Trigger
and
Pattern.
When a data capture is started with
Don’t care (Snapshot)
selected, the analyzer will
trigger on the first data pattern detected. Starting a data capture with
Pattern
selected
the analyzer will trigger when user specified pattern(s) are detected in the captured
data stream. The following are three ways to trigger the analyzer with
Pattern
selected.
•
Trigger on any added pattern (Any Trigger Mode)
•
Trigger on timer
•
External Trigger
•
Trigger on a sequence of patterns (Sequential Trigger Mode)
Snapshot Mode
To trigger immediately on any pattern, check the
Don’t care (Snapshot)
button.
Figure 14. Default Trigger Selected
Manual Trigger Mode
In the
Manual Trigger
mode the analyzer captures traffic continually until you click
the
Stop Hardware
button on the analyzer toolbar which triggers the analyzer. To set
up to perform a manual trigger, check the
Manual Trigger
option
button. Note that in
this mode the Trigger Pointer does not appear in the captured data Packet View
Summary of Contents for AirCom UWB Analyzer
