For Customer Assistance:
www.evolutionlightingllc.com
Made In China
ASSEMBLY INSTRUCTIONS
1.
Carefully unpack and lay all parts on a clean, level, protected
surface so as to prevent any damages to the finish during assembly.
2.
Assemble bottom supporting shelf (G) .
See Fig 1
a. Remove the pre-assembled screws (G3) from shelf half (G2).
b. Align shelf halves G1 and G2 so the upright leg holes are on the same
plane and insert ends of G2 into G1 and secure with screws G3.
3.
Assemble the lampbody:
See Fig 2.
Note: Gently pull the power cord through the four tubes and
the shelf holes during assembly.
a. Insert and thread the four leg sections (E1) to the four leg stubs of
the socket assembly (D).
b. Insert and thread the four leg sections (E2) to the four leg sections (E1).
c. Insert and thread the four leg sections (E3) to the four leg sections (E2).
d. Insert support shelf (G) onto the four leg sections (E3) and secure with
leg feet (F). The leg hole openings on shelf (G) should face the bottom.
4. Attach one end of each chain section (J) to each of the four holes on
the flower pot (I).
Attach the upper portion of each chain section (J) to the desired height
on the leg assembly (D) making sure the flower pot (I) is level.
Note: Maximum weight capacity of flower pot (I) with plant and water
should not exceed 12 lbs.
5. Place the plastic tray (H) on the shelf (G).
6. Install the light bulb (not included) into the socket assembly (D).
7. Pinch and insert the harp (C) into the the harp fittings on the
socket assembly (D). Slide the caps on the harp (C) over the fittings
on the socket assembly (D) to secure.
8.
Assemble the shade (B):
See Fig 3.
a. Hold shade (B1) upside down with the small opening of the shade
resting on a flat,hard surface.
b. Insert the closed end of the U shaped shade frame (B2) so it seats
on the inside of the shade (B1) top opening and stretch shade
upwards until the stubs on the shade frame (B2) can be inserted
into the tubes on shade (B1) bottom rim.
9. Remove the finial (A) from the harp (C), place the shade (B) onto
the harp (C) and secure with finial (A).
10. Insert the plug into an electrical outlet.
11. Use the rotary switch on the socket assembly (D) to adjust uplight
from low, medium, high, and off intensity.
12. Use the timer on the socket assembly (D) to adjust how much grow
light your plant will require.
Note: Please charge at least 6 hours before using the timer.
A
B
C
D
J
I
H
G
F
