23
23
Disconnecting the BABY ZERO PLUS from the BASE FIX BABY ZERO PLUS
Pull the release device found on the backrest of the Baby Zero Plus (fig.18). The
•
indicators on the front part of the base fix baby zero plus will turn red, indicating that the
seat has been correctly disconnected.
Pull the seat upwards (fig.19).
•
Installing the Baby Zero Plus on the pushchair
This exclusive fastening system means that the Baby Zero Plus can be used on the
following pushchairs: Vintage, Vintage2, Vintage3, Jazz, S4, Downtown, S4-reverse,
S-twinner, Avant, Kudu and Kudu mood. For all of them the procedure to fit the Baby
Zero Plus is the following:
Put the parking brake on.
•
Place the Baby Zero Plus on the pushchair, facing backwards.
•
Line the Unisystem fasteners on the Baby Zero Plus up with the slots (fig.20).
•
Press downwards until it clicks fastened and a green signal appears in each of the
•
windows on the sides of the fasteners (fig.21).
To take the Baby Zero Plus off, press and then release the red button on both fasteners
•
(red signal in the window) and pull upwards to release it from the pushchair chassis
(fig.22).
Using the Baby Zero Plus as a rocker
Place the Baby Zero Plus on the floor on a flat surface.
•
Move the handle to the rocker position (consult the section about how to adjust the
•
carrying handle). Make sure that it clicks into position (fig.5) (C).
The Baby Zero Plus will move as your baby moves.
•
The baby should wear the harness fastened and should never be left alone.
•
WARNING: Never leave the child unsupervised.
Using the Baby Zero Plus as a seat
• Place the Baby Zero Plus on the floor on a flat surface.
• Move the handle to the stability position (consult the section about how to adjust the
carrying handle). Make sure that it clicks into position (fig.5) (A).
• The Baby Zero Plus can now be used as a seat for the baby.