background image

 

CB

W383G1IND    Cable Modem Quick Installation Guide

 

Package Contents 

 

 

CBW383G1IND cable modem * 1 

 

Quick Installation Guide * 1 

 

 

RJ-45 CAT 5E cable * 1 

 

12 V/1A Power Adaptor * 1

 

 

 

Rear Panel and Hardware Connection 

 

This chapter describes the proper steps for connecting your cable modem. Please be sure to follow 
the steps in the sequence outlined below. Failure to do so could result in improper operation or failure 
of your cable modem. 

 

 

 
 

Step 1:

Connect a cable by feeding the F-connector on the back of the cable modem. Ensure the 

center conductor of the 75 ohm coaxial cable is inserted directly into the center of the F-connector. 
Secure the coaxial cable by carefully threading the outer shell of the coaxial cable connector onto the 
F-connector in a clockwise direction until tight. Be careful not to over-tighten the connector or you may 
damage either the connector or the cable modem. 

 
Step2

: Connect the cable modem to an IEEE 802.3 10Base-T / 802.3u 100Base-TX / 802.3ab 

1000Base-T Network using a RJ-45 male-terminated Ethernet cable. This cable modem equips with 
one Ethernet port, you can connect PC to the cable modem. 
 

Step 3: 

Connect the AC Adapter to the cable modem by inserting the barrel-shaped connector into the 

mating power connector on the back of the cable modem. Exercise carefully to ensure the connectors 
are properly aligned prior to insertion and ensure the two connectors engage completely. The cable 
modem is shipped with an AC adapter. Remember to use only power adapter that came with the cable 
modem. Other power adapters might have voltages that are not correct for your particular cable   

Step 1

   

Connecting 

the Coaxial Cable

 

Step 2

   

Connecting to a 

Network Interface Cord 

Step 3

   

Connecting 

to the AC Adapter

 

Summary of Contents for CBW383G1IND









Reviews: