Scissor Lift
QJY-S3
10
factors which cannot be built into this product, but must be supplied by the
operator.
2
Environmental condition and specifications
2.1 Ambient temperature of normal operation
The normal operating temperature of the equipment is 5
℃
~ +40
℃
.
The equipment operates normally at 30% ~ 80% RH without condensation.
The equipment operates normally at an altitude below 1000m.
2.3 Noise emission declaration
Noise emission level during normal running of the machine is not exceeding 70 dB.
2.4 specification of the machine
Item
Description
Electric power supply
115V/230V
60Hz/50Hz /Single Phase
Rated power
2.2 kW
Maximum Lifting Capacity
2700kg
Minimum Lift Height
178mm At Pads
Maximum Lift Height
1370mm At Pads
Overall Dimensions
2534mmL*1000Wmm*178mmH(Fully
Lowered)
Weight
385kg
3 Assembly
instructions
NOTE:
For additional references to the parts listed in the following pages, refer to the
Assembly diagrams on pages 16, 17 and 18.
3.1
Determine the Proper Scissor Lift Location:
1.
Do not use the scissor lift in any asphalt surface.
Make sure the scissor lift is used on a
dry, oil/ grease free, flat, level,
CONCRETE
surface capable of supporting the weight of
the scissor lift, the vehicle being lifted, and any additional tools and equipment. The
concrete floor surface should have a minimum thickness of 5”. The concrete must have a
minimum strength of 4,000 PSL, and should be aged at least 30 days prior to use. Do not
use the scissor lift in concrete expansion seams or on cracked, defective concrete.
2.
Make sure to check the desired location for possible obstruction such as a low ceiling,
overhead lines, adequate working area, access ways, exits, etc.