Scissor Lift
QJY-S3
11
3.
Make sure to allow a minimum space of 14 feet in front and behind the scissor lift to
accommodate all vehicles. Certain allowance should be made for special vehicle
requirements or unusual floor plans.
3.2
To attach the Hydraulic Pump to the Scissor Lift
1.
Locate the hydraulic pump unit (1A through 15A) in an area where it will be out of the
way, is safe from damage and weather, and where it can be easily reached to operate.
(See
Figure E.)
2.
One end of the general inlet pipe (18B) has been pre-attached to the scissor lift by the
manufacturer. To attach the remaining end of the general inlet pipe to the hydraulic pump
wrap the male threads of the oil pipe connector(17B) with about 4” of pipe thread seal
tape (not included). Remove the oil filler nut cap (4A) from the threaded hydraulic oil
delivery port. Then, wrench tighten the oil pipe connector into the hydraulic oil delivery
port.
(See Figure E.)
