Castelle FAXPRESS PREMIER, Administrator'S Manual

Page: 582 / 639

Admin Guide > Analog Hardware Upgrade
566
Upgrading with an Additional Analog Board
Follow the steps in this section only if the unit you’re upgrading has already had at least
one additional fax board added to it. To add an upgrade board to a unit that has already
been upgraded with an additional fax board, follow these steps:
1. Discharge static electricity from yourself by touching a grounded surface, attach a
grounded static-dissipative wrist strap, and make sure the working sur-face is
static-dissipative and grounded.
2. Shut down the FaxPress Premier from the console by accessing the System Infor-
mation folder in the System & Diagnostics folder, and then right-clicking on the
blank section of the list to the right side of the Faxmain window and choosing the
System Shutdown command. When the system has shut down, disconnect the
power cord from the unit.
3. Remove the 5 cover screws holding the cover of the FaxPress Premier to the back
panel, the 3 screws holding the bottom of the cover to each side of the chassis,
and the 2 screws holding the front edge of the cover under the lip at the top of the
front panel (the screw directly above the thumbscrew for the fan unit cover does
not need to be removed, but may need to be loosened slightly, as shown below.
Note: Remove only the FaxPress Premier cover screws. Do not remove any
other chassis screws.