Cassidian TPM700, Technical Manual

Page: 69 / 88

Vehicle-Mounted TPM700 Technical Manual TMO - PS11061AENAA01 Page
Maintenance 14/10/08 4-39
T
his document is the pro
perty of EADS Secure Ne
tworks
and should
not be copied or circ
ulated
with
out permission
Ce document est la prop
rié
té de EADS Secure Net
w
orks et
ne doit pas être r
eprod
uit ou
communiqué sans autor
isation
7
1
2
3
4
5
REPLACING THE POWER SUPPLY FILTER
OPERATOR(S)
• 1 operator
TIME REQUIRED
• 30 minutes
TOOL(S)
• Standard tool box
• 1 set of insulated screwdrivers for slot-head screws (2.5 mm, 3.5 mm, 4 mm).
PRELIMINARY OPERATION(S)
• If necessary, switch off the CH by pressing and holding down the key (Figure 2.3,
item 2) on the CH.
REMOVAL
• Disconnect the various cables from the power supply filter:
- release the 2-pin female AMP connector (
Figure 4.7
, item
7
) and disconnect it from
the 2-pin male AMP 2 connector (item
6
) on the power supply filter.
- release the 2-pin male AMP 2 connector (item
4
) and disconnect it from the 2-pin
female AMP connector (item
5
) on the power supply filter.
• Unscrew and remove the two screws (item
3
) securing the power supply filter (item
1
) to
the simplified BER bracket (item
2
).
• Remove the power supply filter (item
1
) from the simplified BER bracket (item
2
).
SHEET E-3