Cassese CS200 CART, User & Parts Manual

Page: 19 / 64

USER MANUAL CS200 CART
19
4 JOINING THE FRAME
Release the pedal once the joining is done. It is possible also to shoot wedges (and even to stack them), between the two stops.
Put The right side
moulding on the
table as per image.
Then
push the
moulding until it
reaches the opposite
stop.
Put
the second
moulding on the
table.
Rotate the joystick
and move it to the
desired stop. Joining
can be done starting
from
inside or
outside position.
Figure 4-1
Figure 4-2
Press the pedal to
clamp the mouldings
together.
The
horizontal
clamps will move up
to the moulding.
Figure 4-3
Press the top button of
the joystick to insert the
wedge
inside the
moulding.
Keep the button
pressed until the
machine releases the
vertical clamp
.
Press a second time the
button if another wedge
needs to be stacked in
this position. Keep pedal
pressed during this
process.
Figure 4-4
Rotate the joystick
and move it to the
second stop.
Figure 4-5
Still with the pedal
pressed, press the top
button of the joystick to
insert the wedge inside
the moulding.
Keep the button
pressed until the
machine releases the
vertical clamp
.
Press a second time the
button if another wedge
needs to be stacked in
this position. Keep pedal
pressed during this
process.
Figure 4-6