Casio FX-6300G, Owner'S Manual

Page: 34 / 187

■Calculation modes
This unit features modes for manual calculations, storing programs, and modes
for general as well as statistical calculations. The proper mode to suit calculation-
al requirements should be employed.
• Operation modes
There are a total of three operation modes.
1. RUN mode
Graph production as well as manual calculations and program executions.
2. WRT mode
Program storage and editing. (See Section 4.)
3. PCL mode
Deletion of stored programs. (See Section 4.)
• Calculation modes
There are a total of six calculation modes which are employed according to the
type of calculation.
1. COMP mode
General calculations, including functional calculations.
2. BASE-N mode
Binary, octal, decimal, hexadecimal conversion and calculations, as well as
logical operations. (See page 62.) Function calculations and graph drawing can­
not be performed.
3. SD1 mode
Standard deviation calculation (single-variable statistics). (See page 67.)
4. SD2 mode
For production of bar graph or normal distribution curve according to single­
variable statistical data. (See page 97.)
5. LR1 mode
Regression calculation (paired-variable statistics). (See page 69.)
6. LR2 mode
For production of regression line graph according to paired-variable statistical
data. (See page 100.)
With so many modes available, calculations should always be performed after
confirming which mode is active.
• IMPORTANT: When the power of the unit is switched off (including Auto Power
Off), the current system mode is cancelled, and the unit will be set to the RUN
mode when switched on again. However, the calculation mode, number of decimal
place setting (ImqqeIITIai), number of significant digits (H Q E )«), and angle unit (Deg,
Rad, Gra) will be retained in memory.
*To return to standard operation (initialized state) press B B S (COMP mode) —
r a m (RUN mode) — H ® (Norm mode).
- 3 2 -