12
Introduction (Basic Operation)
Replacing the battery
1.
Press [
p
] (Power) to switch
the camera off and then open
the battery cover.
2.
Remove the battery and insert
a new battery.
3.
Close the battery cover.
IMPORTANT!
• When you have pressed [
p
] (Power) to switch the camera off, do not remove the
battery while the operation check indicator (page 7) is flashing green. Doing so
may cause data to be deleted or corrupted.
There are two ways to charge the battery, as outlined below.
Charging using the AC adapter for camera charging (AD-M50300A)
Charging using the Battery Charger Set (DCS-100M (sold separately))
.
Charging using the AC adapter for camera charging
This method charges the battery while it is in the camera.
With the camera switched off, connect the cable in the sequence shown as
,
.
Charging time: Approx. 4 hours 30 minutes
• When disconnecting the adapter from the camera, always disconnect the camera
end of the cable (
in the above diagram) first.
Charging
Stopper
DC IN
USB
HDMI OUT
Operation check indicator
Orange: Charging
Off: Charging completed
AC adapter
Cable
