Adjusting Hand and
Day Indicator
Alignment
Strong magnetism or impact can cause the
hands and/or the day indicator to go out of
alignment. If this happens, adjust hand and
day indicator alignment.
●
The watch performs alignment of the hour
hand, minute hand, and second hand
automatically.
Adjusting Hand and Day
Indicator Alignment
1.
Loosen the crown and then pull it out to the
second click.
2.
Hold down (D) for at least five seconds
until the second hand points to 12 o’clock .
Release the button when the second hand
reaches 12 o’clock.
This will start auto alignment of the hour
hand, minute hand, second hand, and 24-
hour hand.
●
After auto alignment is complete, the
hands should be in the positions shown
below.
30
Second hand
Minute hand
Hour hand
Crown
24-hour hand
3.
Press (C).
Confirm that the small hour and minute
hands, and the small 24-hour hand are all
stopped at 12 o’clock.
30
Small minute hand
Small hour hand
Small 24-hour hand
4.
If the small hour and minute hands, and
the small 24-hour hand are not at 12
o’clock, rotate the crown to align them with
12 o’clock.
5.
Press (C).
Confirm that the mode hand is stopped at
12 o’clock, and check if the day is
indicated properly.
30
30
Day (Operation start day)
Mode hand
6.
If the mode hand and/or the day indicator
is out of alignment, rotate the crown to
move the mode hand to 12 o’clock and the
day to the center of the indicator window.
●
The movement range of the mode hand
and day indicator is limited when you
rotate the crown. The maximum left-
right movement of the mode hand is 180
degrees in either direction. The day
indicator moves only slightly.
●
After the mode hand and day indicator
are in the positions you want, advance
to step 9 of this procedure. If you are
unable to make the adjustments you
want, go to step 7.
7.
Press (C).
Confirm that the day indicator shows 1.
30
1
Day
●
Changing the date setting will cause the
mode hand to rotate repeatedly. In
some cases, the mode hand may
continue to rotate for about 5 minutes.
l
Hand and Day Indicator Movement
8.
If 1 is not shown for the day, rotate the
crown until 1 is shown for the day.
●
The mode hand moves in conjunction
with crown rotation. Move the mode
hand to 12 o’clock.
9.
Push the crown back in and then lock it.
Note
●
Leaving the crown pulled out for more
than approximately 30 minutes without
performing any operation will
automatically cause the adjustment
operation to become disabled. If this
happens, push the crown back in to its
normal position and then pull it out
again to restart the procedure from the
beginning. Pushing the crown in to its
normal position part way through the
alignment procedure will cause the
hands to return to their normal position.
Any alignment you performed up to
that point will be applied.
Other Settings
This section explains other watch settings you
can configure.
Resetting Watch Settings
This section explains how to return the watch
settings below to their initial factory defaults.
●
Watch Settings
●
Stopwatch
●
Timer
●
Alarm
●
Port specification
●
Diving log
1.
Enter the Calendar Mode.
l
2.
Loosen the crown and then pull it out to the
second click.
3.
Hold down (A) for at least five seconds
until the second hand points to 12 o’clock.
30
Crown
Second hand
4.
Push the crown back in and then lock it.
Operation Guide 5623
20
