Connection
Connecting with a Phone
This section explains how to establish a
Bluetooth connection with a phone that is
paired with the watch.
●
If the watch is not paired with the phone you
want to connect with, refer to the information
below and pair them.
l
1.
Move the phone close to (within one meter
of) the watch.
2.
X
Hold down (C) for at least 1.5 seconds
until [CONNECT] starts to flash.
When a connection is established
between the watch and phone,
[CONNECT] will stop flashing and the
second hand will move from [R] to
e
.
●
If connection fails for some reason,
[ERR] will appear on the display
momentarily and then the watch will
return to the mode it was in before you
started the connection procedure.
Trying to connect
Connected
Important!
●
If you have problems establishing a
connection, it could mean that
EDIFICE Connected is not running on
the phone. On the phone’s home
screen, tap the “EDIFICE Connected”
icon. After the app starts up, hold down
the watch’s (C) button for at least 1.5
seconds.
Note
●
The connection will be terminated if
you do not perform any operation on
the watch or phone for a fixed amount
of time.
To specify the connection limit time,
perform the following operation with
EDIFICE Connected: “Watch
settings”
n
“Connection time”. Next,
select a setting of 3 minutes, 5 minutes,
or 10 minutes.
Disconnecting from a Phone
Pressing any button will terminate a Bluetooth
connection and return to the Timekeeping
Mode.
Connected
Disconnected
Using the Watch in a Medical Facility
or Aircraft
Whenever you are in a hospital, on an aircraft,
or in any other location where auto signal
receive or connection with a phone may cause
problems, you can perform the procedure
below to disable it. To re-enable auto time
adjustment, perform the same operation
again.
1.
X
If the watch is in any mode besides the
Timekeeping Mode, hold down (D) for at
least two seconds to enter the
Timekeeping Mode.
2.
X
Hold down (A) for at least two seconds
until the name of the currently selected
Home City is displayed.
3.
X
Press (D) 14 times.
This displays [RCV].
4.
X
Press (E) to select the auto time
adjustment setting you want.
[OFF]: Auto time adjustment disabled.
[ON]: Auto time adjustment enabled.
5.
X
Press (A) to exit the setting screen.
Unpairing
1.
X
If the watch is connected with a phone,
press any button to terminate the
connection.
Connected
Disconnected
2.
Y
Tap the “EDIFICE Connected” icon.
3.
Y
Perform the operation shown on the
phone screen to unpair.
If you purchase another phone
You need to perform the pairing operation
whenever you want to establish a Bluetooth
connection with a phone for the first time.
l
Stopwatch
The stopwatch measures elapsed time in
1/1000-second units for the first hour, and in
1/10-second units after that for up to 24 hours.
In addition to normal elapsed time
measurements, the stopwatch also lets you
measure lap times. You can also set a target
time and monitor your progress in reaching it.
You can configure settings so the watch beeps
when you reach your target time.
Note
●
Up to 200 lap time records can be
stored in watch memory. You will not
be able store any more lap times when
there are already 200 records in
memory.
●
You can use the Recall Mode to view
the latest measurement data.
l
●
You can use EDIFICE Connected to
view past measurement data.
Operation Guide 5537
9