Casio 5537, Operation Manual, Page: 10 / 23

Getting ready
Enter the Stopwatch Mode.
l
Navigating Between Modes
Measuring Elapsed Time
1.
Use the operations below to measure
elapsed time.
E
A
E
A
Stop
Resume
Stop
Start
●
Elapsed time is shown in 1/1000-
second units for the first hour of the
measurement session. After the first
hour, elapsed time is shown in 1/10-
second units.
After first hour
Hours, minutes, seconds,
1/10 seconds Minutes, seconds,
1/1000 seconds
First hour
2.
Press (A) to reset the elapsed time to all
zeros.
Measuring Lap Times
1.
Use the operations below to measure
elapsed time.
●
Each press of (E) causes the elapsed
time of the section (lap time) to be
shown for eight seconds.
E
E
A
Stop
Start
Lap
●
Elapsed time is shown in 1/1000-
second units for the first hour of the
measurement session. After the first
hour, elapsed time is shown in 1/10-
second units.
After first hour
Hours, minutes, seconds,
1/10 seconds Minutes, seconds,
1/1000 seconds
First hour
2.
Press (A) to reset the elapsed time to all
zeros.
Performing a Stopwatch
Measurement with a Target
Time
You can perform lap time measurement
operations while checking the difference
between the lap time and a target time.
●
Using a Stopwatch Target Time
Specifying a Target Time
You can specify one of three target times.
FASTEST :
Following start of a stopwatch elapsed time
measurement session, the fastest measured
lap time of the current session is automatically
set as the target time.
TARGET :
You can use EDIFICE Connected to specify a
desired target time.
If you use the watch without connection with a
phone, the target time is automatically set to
15 minutes.
LAST :
Following start of a stopwatch elapsed time
measurement session, the last measured time
of the current session is automatically set as
the target time.
1.
Hold down (A) for at least two seconds.
2.
Press (E) to cycle through the target time
types.
3.
Press (A) to exit the setting screen.
Measuring Elapsed Time
Each time you press (E) to measure a lap time,
the second hand indicates the difference
between the lap time and the target time.
E
E
E
E
A
Lap 1
Start
Stop
Lap 2
Lap 3
[TARGET] Target Time Type :
You can check the difference between the
measured lap time and the target time from the
first lap onwards.
[FASTEST] or [LAST] Target Time Type :
You can check the difference between the
measured lap time and the target time from the
second lap onwards.
Operation Guide 5537
10