Casio 3513, Operation Manual

Page: 21 / 34

●
To start measurement
1.
Enter the Altimeter Mode.
l
Navigating Between Modes
2.
Hold down (A) for at least five seconds.
Release the button when [Trek] and
mountain climbing graphic segments
appear on the display.
This starts recording of altitude data (high/
low altitude, cumulative ascent/descent).
Mountain climbing
graphic segments
●
Mountain climbing graphic segments
flash or are displayed around the
periphery of the display while recording
is in progress. Each segment
represents 12 minutes, and one lap
around the periphery represents 12
hours.
●
To stop measurement
1.
Enter the Altimeter Mode.
l
Navigating Between Modes
2.
Hold down (A) for at least five seconds.
Release the button when [Trek]
[END]
appears on the display.
This stops altitude data (high/low altitude,
cumulative ascent/descent) recording.
Note
●
If you want to record more than 15 data
records, delete old records to make
room for the new data.
l
Deleting a Particular Record
●
Auto Record and Climb Record Data
Contents
The altitude data below is recorded by auto
record and climb record operations.
A
B
C D
F
E
End point
Start point
High Altitude (MAX): E
Low Altitude (MIN):
F
Cumulative Ascent (ASC): A + C *
Cumulative Descent (DSC):
B
+
D
*
* Cumulative ascent and cumulative descent
values are updated whenever there is a
difference of at least ±15 m (±49 feet) from
one reading to the next.
Note
●
In the case of auto record data, the
auto record operation ends if you exit
the Altimeter Mode. Re-entering the
Altimeter Mode restarts recording of
cumulative values from where it was
stopped when you last exited the
Altimeter Mode.
●
For climb record data, auto
measurement continues even if you
exit the Altimeter Mode.
Specifying the Altitude
Measurement Unit
You can select either meters (m) or feet (ft) as
the Altimeter Mode display unit.
Important!
●
When Tokyo (TYO) is set as the Home
City, the altitude unit is fixed as meters
(m) and cannot be changed.
1.
Enter the Timekeeping Mode.
l
Navigating Between Modes
2.
Hold down (E) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
Example: When your Home City is
London
Home City
3.
Press (D) 12 times.
This displays [UNIT].
4.
Use (A) to select an altitude unit.
[m]: Meters
[ft]: Feet
Feet Meters
5.
Press (E) twice to complete the setting
operation.
Watch Operation Guide 3513
21