Casio 3452, Operation Manual

Page: 8 / 41

Using the Watch in a Medical
Facility or Aircraft
When you are in a hospital, on an aircraft, or
in any other location where radio signals may
cause problems, you can perform the
procedure below to enter the watch’s Airplane
Mode, which disables auto GPS signal
receive and connection with a phone. To re-
enable auto time adjustment, perform the
same operation again.
1.
Enter the Timekeeping Mode.
l
Navigating Between Modes
Rotary Switch
2.
Press (A).
This displays the Timekeeping Mode
setting screen.
3.
Rotate the rotary switch to move the
pointer to [AIRPLANE MODE].
4.
Press the rotary switch.
5.
Rotate the rotary switch to select the
Airplane Mode setting.
[ON]: Airplane Mode enabled
[OFF]: Airplane Mode disabled.
6.
Press the rotary switch to exit the setting
screen.
This returns to the Timekeeping Mode
setting screen.
7.
Press (C) to exit the setting screen.
●
is displayed while the watch is in the
Airplane Mode.
Connecting the Watch with a
Phone
Connecting with a Phone
This section explains how to establish a
Bluetooth connection with a phone that is
paired with the watch.
●
If the watch is not paired with the phone you
want to connect with, perform the procedure
under “
C
Pair the watch with a phone. ” to
pair them.
1.
Move the phone close to (within one meter
of) the watch.
2.
Y
On the Home Screen, tap the “G-
SHOCK Connected” icon.
3.
X
Enter the Communication Mode.
l
Navigating Between Modes
●
[CONNECTED] appears on the watch
display appears when a connection is
established with the phone.
●
[CONNECT FAILED] will appear if
connection fails for some reason.
Important!
●
If you have problems establishing a
connection, it could mean that G-
SHOCK Connected is not running on
the phone. On the phone’s home
screen, tap the “G-SHOCK
Connected” icon. After the app starts
up, enter the Communication Mode on
the watch.
Note
●
The connection will be terminated if
you do not perform any operation on
the watch or phone for a fixed amount
of time.
To specify the connection limit time,
perform the following operation with G-
SHOCK Connected: “Watch settings”
n
“Connection time”. Next, select a
setting of 3 minutes, 5 minutes, or 10
minutes.
Disconnecting from a Phone
Pressing any button will terminate a Bluetooth
connection and return to the Timekeeping
Mode.
Disconnected Connected
Configuring Watch Settings
After establishing a connection between the
watch and a phone, you can use G-SHOCK
Connected to configure watch settings and to
view information acquired by the watch.
1.
Y
Tap the “G-SHOCK Connected” icon.
2.
X
Enter the Communication Mode.
l
Navigating Between Modes
●
[CONNECTED] appears on the watch
display appears when a connection is
established with the phone.
●
[CONNECT FAILED] will appear if
connection fails for some reason.
3.
Y
Select the setting you want to change
and then perform the operation shown on
the phone screen.
Phone Finder
You can use phone finder to trigger a tone on
the phone to make it easy to find. The tone is
forced to sound even if the phone is in vibrate
mode.
Important!
●
Do not use this function in areas where
phone call tones are restricted.
●
The tone sounds at a high volume. Do
not use this function when listening to
phone output over earphones.
1.
X
Enter the Timekeeping Mode.
l
Navigating Between Modes
Rotary Switch
Operation Guide 3452
8