Operation Guide 3218 3289
MO1312-EA
E-1
Getting Acquainted
Congratulations upon your selection of this CASIO watch. To get the most out of your
purchase, be sure to read this manual carefully.
•
Be sure to keep all user documentation handy for future reference.
Warning!
•
The measurement functions built into this watch are not intended for taking
measurements that require professional or industrial precision. Values produced
by this watch should be considered as reasonable representations only.
•
The Moon phase indicator and tide graph data that appear on the display of this
watch are not intended for navigation purposes. Always use proper instruments
and resources to obtain data for navigation purposes.
•
This watch is not an instrument for calculating low tide and high tide times. The
tide graph of this watch is intended to provide a reasonable approximation of
tidal movements only.
E-2
Keep the watch exposed to bright light
The electricity generated by the solar cell of the watch is
stored by a rechargeable battery. Leaving or using the
watch where it is not exposed to light causes the battery
to run down. Make sure the watch is exposed to light as
much as possible.
•
When you are not wearing the watch on your wrist,
position the face so it is pointed at a source of bright
light.
•
You should try to keep the watch outside of your sleeve
as much as possible. Charging is reduced significantly if
the face is covered only partially.
ll
l
l
l
l
l
l
l
l
l
Bright Light
Solar cell
E-3
All
functions
enabled
LEVEL 1
LEVEL 2
LEVEL 3
LEVEL 4
Charge
Rechargeable battery
Bright Light
Electrical
energy
Solar cell
(Converts light to
electrical power.)
LEVEL 1
LEVEL 2
LEVEL 3
LEVEL 4
Some or all
functions
disabled
Dis-
charge
Battery charges in the light.
Battery discharges in the dark.
•
The watch continues to operate, even when it is not exposed to light. Leaving the
watch in the dark can cause the battery to run down, which will result in some watch
functions to be disabled. If the battery goes dead, you will have to re-configure watch
settings after recharging. To ensure normal watch operation, be sure to keep it
exposed to light as much as possible.
E-4
•
The actual level at which some functions are disabled depends on the watch model.
•
Frequent display illumination can run down the battery quickly and require charging.
The following guidelines give an idea of the charging time required to recover from a
single illumination operation.
Approximately 5 minutes exposure to bright sunlight coming in through a window
Approximately 8 hours exposure to indoor fluorescent lighting
•
Be sure to read “Power Supply” (page E-42) for important information you
need to know when exposing the watch to bright light.
E-5
If the display of the watch is blank...
If the display of the watch is blank, it means that the watch’s Power Saving function
has turned off the display to conserve power.
•
See “Power Saving Function” (page E-58) for more information.
E-6
About This Manual
•
Depending on the model of your watch, display text appears either as dark figures
on a light background or light figures on a dark background. All sample displays in
this manual are shown using dark figures on a light background.
•
Button operations are indicated using the letters shown in the illustration.
•
Each section of this manual provides you with the information you need to perform
operations in each mode. Further details and technical information can be found in
the “Reference” section.
lll
llll
ll
lll
llll
ll
E-7
Contents
General Guide ....................................................................................................... E-10
Timekeeping .......................................................................................................... E-12
Tide/Moon Data ..................................................................................................... E-18
World Time ............................................................................................................. E-25
Alarms .................................................................................................................... E-28
Stopwatch .............................................................................................................. E-33
Countdown Timer .................................................................................................. E-35
Illumination ............................................................................................................ E-38
Power Supply ........................................................................................................ E-42
Reference .............................................................................................................. E-50
Specifications ....................................................................................................... E-64
E-8
Procedure Lookup
The following is a handy reference list of all the operational procedures contained in
this manual.
To set the time and date ....................................................................................... E-13
To change the Daylight Saving Time (summer time) setting ............................ E-17
To adjust the high tide time ................................................................................. E-22
To reverse the displayed Moon phase ................................................................ E-24
To view the time in another city ........................................................................... E-26
To toggle a city code time between Standard Time and
Daylight Saving Time ...................................................................................... E-27
To set an alarm time ............................................................................................. E-29
To test the alarm ................................................................................................... E-30
E-9
To turn an alarm on and off .................................................................................. E-31
To turn the Hourly Time Signal on and off .......................................................... E-32
To measure times with the stopwatch ................................................................ E-34
To configure the countdown timer ...................................................................... E-36
To use the countdown timer ................................................................................ E-37
To illuminate the display manually ...................................................................... E-38
To specify the illumination duration ................................................................... E-39
To turn the auto light switch on and off .............................................................. E-41
To turn the button operation tone on and off ..................................................... E-57
To recover from the sleep state ........................................................................... E-59
To turn Power Saving on and off ......................................................................... E-59
