Case CX800 Tier 3, Service Manual

Page: 40 / 51

1002-29
Lep 9-94710NA Issued 06-06
SPECIAL TORQUE SETTINGS
NOTE: Use Loctite 262 or an equivalent on retaining screws of those components marked with an asterisk (*).
No. Component Screw Wrench (mm) Torque setting
1 * Travel motor and reduction gear assembly M27 41 1307-1526 Nm (964 - 1125 lb-ft)
2 * Sprocket M27 41 1307-1526 Nm (964 - 1125 lb-ft)
3 * Idler wheel
4 * Upper roller M20 30 521-608 Nm (384-448 lb-ft)
5 * Lower roller M27 41 1307-1526 Nm (964-1125 lb-ft)
6 * Chain guide M30 46 1307-1526 Nm (964-1125 lb-ft)
7 Track pad M27 30 1588-1869 Nm (1171-1378 lf-ft)
8 Counterweight M42 65 2256-2550 Nm (1664-1880 lb-ft)
9* Turntable (frame) M30 46 1800-2100 Nm (1328-1549 lb-ft)
10* Turntable (upperstructure) M30 46 1800-2100 Nm (1328-1549 lb-ft)
11 * Swing motor and reduction gear assembly M24 36 900-1050 Nm (664-775 lb-ft)
12 * Engine M24 36 902-1049 Nm (665-774 lb-ft)
13 * Engine bracket M14 22 173-202 Nm (128-149 lb-ft)
14 Radiator M20 30 520-608 Nm (384-448 lb-ft)
15 * Hydraulic pump M12 19 109-127 Nm (80-94 lb-ft)
16 * Hydraulic reservoir M20 30 471-258 Nm (347-419 lb-ft)
17 * Fuel reservoir M20 30 471-258 Nm (347-419 lb-ft)
18 * Control valve M20 30 343-392 Nm (253-289 lb-ft)
19 * Hydraulic swivel
M12 19 109-127 Nm (80-94 lb-ft)
M16 24 267-312 Nm (197-230 lb-ft)
20 Cab M16 24 78-80 Nm (58-59 lb-ft)
21 Battery M10 17 20-29 Nm (15-21 lb-ft)
22 Frame M36 55 2550-2942 Nm (1880-2170 lb-ft)
23 Frame M30 46 1781-2078 Nm (1314-1533 lb-ft)
24 Air cleaner