Case CX490D, Operator'S Manual

Page: 220 / 370

6 - MAINTENANCE
Travel reduction units oil
Check the travel reduction gears oil level every 250 h .
Lubricant: T
UTELA
H
YPOIDE
EP G
EAR LUBE
SAE 80W-90
1. Park the machine on flat, horizontal ground.
2. Move the machine so that the drain plug (1) comes
down to the lowest position.
3. Stop the engine and remove the starter key.
4. Remove the level plug (2) , and check the oil level. If
the level comes up to the bottom edge of the port (2) ,
it is sufficient.
If necessary, add oil through the port (2) until the oil
comes up to the bottom edge of the port (2) .
5. Check the O-ring seal of the level plug (2) for damages,
and replace it if necessary. Insert the level plug (2) with
seal tape wrapped around it.
6. Repeat Steps 2 to 5 for the other travel reduction gear.
7. Run the machine slowly to check that there are no
leaks.
SMIL15CEXY509AB
1
6-26