Case CX130C, Operator'S Manual

Page: 69 / 282

3 - CONTROLS AND INSTRUMENTS
Cab internal lighting
The room lamp allows to have internal lighting near to the
operator's station. The room lamp has a control switch
with three operating positions:
• OFF
• DOOR
• ON
When the switch is set in DOOR position, the room lamp
turns on automatically when the door is opened, and turns
off automatically when the door is closed.
NOTE: If the door is left open for more than 30 s , the lamp
is forcedly turned off in order to prevent drain of the battery
charge.
The ON position of the switch allows to turn on the room
lamp only if the starter key is set in ACC or ON position.
NOTICE: Never leave the room lamp switch in ON posi-
tion. The battery charge may be drained out. As the need
for lighting ends, set the switch to OFF or DOOR position.
SMIL14CEX2568AA
1
Emergency exit hammer
Located on the left-hand cab, use the hammer (1) to break
the rear window, and then push the window strongly and
escape outside.
Consult your CASE CONSTRUCTION dealer for window
installation.
NOTICE: Do not break the rear window except when it is
absolutely necessary, such as to escape in an emergency.
NOTICE: Do not place anything in front of the window.
Doing so may obstruct an emergency escape.
SMIL13CEX2621AB
1
Sliding windows on door
The two windows on the cab door can be opened singu-
larly or simultaneously. Release the lock and slide each
window in order to open it.
SMIL14CEX2569AA
1
3-23