Case 721G Stage IV, Operator'S Manual

Page: 97 / 522

3 - CONTROLS AND INSTRUMENTS
Steering column
WARNING
Hazard to bystanders!
Always sound the horn before starting the machine. Make sure the work area is clear of other persons,
domestic animals, tools, etc. before you operate the machine. Never allow anyone in the work area
during machine operation.
Failure to comply could result in death or serious injury.
W0304A
Right-hand multifunction lever
1. Horn
Push the horn button in to actuate the horn.
2. Turn signal lever
Push the control lever up to signal a left
turn. Pull the lever down to signal a right
turn. Move the lever manually to the center
position to stop the signals.
3. High beam headlights and flashing
Pull the multifunction lever to turn on
the high beam headlights. Push the
multifunction lever for flashing.
4. Driving light wheel
Rotate the wheel
(4) to set one of the three
positions:
0 – Lights OFF
1 – Marker/position lights
2 – Low beam headlights
5. Front wiper/washer wheel
Rotate the wheel
(5) to set one of the four
positions:
0 - OFF position.
I - ON position – Rotate clockwise the wheel
(5) to the first position to activate the front
wiper.
L - INTERMITTENT - Rotate clockwise the
wheel
(5) to the second position to activate
the front wiper at the intermittent speed.
H - CONTINUOUSLY - Rotate clockwise
the wheel
(5) to the third position. The front
wiper runs continuously.
WASH - Rotate counterclockwise and hold
the wheel
(5) for washer fluid.
6. Front wiper speed wheel
Rotate the wheel
(6) to adjust and set the
front wiper intermittent speed. There are
six settings for the front wiper intermittent
speed.
LEIL16WHL0542AB
1
3-13