Case 570NXT, Operator'S Manual, Page: 91 / 280

4 - OPERATING INSTRUCTIONS
Normal engine starting
1. Adjust the seat and fasten the seat belt.
2. Make sure the parking brake is applied, the directional control lever is in neutral, and the engine hand throttle (if
equipped) is in the low idle position.
3. Turn the key switch to the ON position and wait two to three seconds for the instrument cluster to self-check and
power up.
4. Wait for the engine pre-heat lamp to turn off.
5. Push the foot throttle 1/4 down and turn the key switch to the START position to actuate the starter motor.
6. If the engine starts and stops, do not actuate the starter motor again until the starter motor stops turning.
NOTE: Do not operate the starter motor more than 30 seconds at one time. Let the starter motor cool for two minutes
before you actuate the starter motor again.
8. After the engine starts:
A. Check the instrument cluster to make sure the gauge indications are correct.
B. Run the engine at 1000 RPM until the coolant temperature is warm.
4-3