Case 570NXT, Operator'S Manual, Page: 61 / 280

3 - CONTROLS/INSTRUMENTS
3 - CONTROLS/INSTRUMENTS ###_3_###
ACCESS TO OPERATOR'S PLATFORM
Machine access
WARNING
Fall hazard!
Jumping on or off the machine could cause an injury. Always face the machine, use the handrails
and steps, and get on or off slowly. Maintain a three-point contact to avoid falling: both hands on the
handrails and one foot on the step, or one hand on the handrail and both feet on the steps.
Failure to comply could result in death or serious injury.
W0141A
WARNING
Fall hazard!
Clean the steps and access handles to remove all traces of grease, oil, mud, and ice (in winter).
Failure to comply could result in death or serious injury.
W0139A
WARNING
Unexpected movement!
Always engage the parking brake and switch off the engine before exiting the machine.
Failure to comply could result in death or serious injury.
W0209A
CAUTION
Fall hazard!
When entering or exiting the cab, never use the control levers as handholds. Always mount and dis-
mount the machine in a safe way. Maintain a three-point contact with steps, ladders, and/or handholds.
Failure to comply could result in minor or moderate injury.
C0075B
Access the platform from either side of the machine.
1. Face the machine.
2. If applicable, fully open the cab door.
3. Grab both hand holds.
4. Use the steps to climb onto the operator platform.
Exit the platform from either side of the machine.
1. Face the inside of the machine.
2. Grab both hand holds.
3. Use the steps to climb down from the operator plat-
form.
RAPH12UTL0186BA
1
3-1