Case 570NXT, Operator'S Manual, Page: 28 / 280

2 - SAFETY INFORMATION
Safety rules - Basic operating
WARNING
Escaping fluid!
Hydraulic fluid or diesel fuel leaking under pressure can penetrate the skin and cause infection or
other injury. To prevent personal injury: Relieve all pressure before disconnecting fluid lines or per-
forming work on the hydraulic system. Before applying pressure, make sure all connections are tight
and all components are in good condition. Never use your hand to check for suspected leaks under
pressure. Use a piece of cardboard or wood for this purpose. If injured by leaking fluid, see your
doctor immediately.
Failure to comply could result in death or serious injury.
W0178A
WARNING
Some components may continue to run down after disengaging drive systems.
Make sure all drive systems are fully disengaged.
Failure to comply could result in death or serious injury.
W0113A
• Always check the operating and the road safety of the
machine before starting.
• Always make sure the working area is clear of other
persons, domestic animals, tools, etc. before you start
operating the machine.
• Another worker or bystander within the operating area
of a machine can be struck or crushed by the machine
or its equipment. DO NOT allow anyone to enter the
work area.
• Always sound horn before starting the machine.
• Never operate the engine in enclosed spaces as harm-
ful exhaust gases may build up.
• Check brakes, steering, and other machine control
devices in accordance with maintenance instructions,
prior to starting operation.
Observe all gauges or
warning instruments for proper operation. Operate all
controls to ensure proper operation. If any malfunc-
tions are found, remove the key and attach a 'Do Not
Operate' tag on the machine until the malfunction is
corrected.
• If a failure that causes loss of control such as steering,
service brakes, or engine occurs, stop the machine mo-
tion as quickly as possible. Make sure the machine is
securely parked. Remove the key and attach a 'Do Not
Operate' tag on the machine until the malfunction is cor-
rected or the machine can be safely towed.
• Make sure all components are in good condition and
tighten all connections before starting the engine or
pressurizing the system.
• Make sure all guards and shields are in good condition
and properly installed before operating machine. Never
operate the machine with the shields removed. Always
close access doors or panel before operating the ma-
chine.
• Before starting the engine, be sure all operating con-
trols are in the neutral or park lock position.
• Start the engine only from the operator’s seat.
• Operate controls only when seated in the operator's
seat, except for those controls expressly intended for
use from other locations.
• Do not allow other persons to ride on the machine or
on an attachment/implement.
• Operate and drive the machine with care and at speed
compatible with conditions. Use extra caution when op-
erating over rough ground, on slopes, and when turn-
ing.
• If your machine has a cab, make sure that all windows
are clean and that the windshield wipers work correctly.
• Dust, fog, smoke, etc., can decrease your vision and
cause an accident. Stop the machine or decrease the
speed until you can see.
• Understand the machine limitations and keep the ma-
chine under control.
• Before you operate at night, check that all lamps illumi-
nate.
• Select a gear that will prevent excessive speed when
going downhill. Do not coast downhill.
• DO NOT attempt to remove material from any part of
the machine while it is being operated or components
are in motion.
2-4