Case 570NXT, Operator'S Manual, Page: 11 / 280

1 - GENERAL INFORMATION
Electro-Magnetic Compatibility (EMC)
Interference may arise as a result of add ‐ on equipment which may not necessarily meet the required standards. As
such interference can result in serious malfunction of the unit and/or create unsafe situations, you must observe
the following:
• The maximum power of emission equipment (radio, telephones, etc.) must not exceed the limits imposed by the
national authorities of the country where you use the machine.
• The electro
‐ magnetic field generated by the add ‐ on system should not exceed 24 V/m at any time and at any
location in the proximity of electronic components.
• The add
‐ on equipment must not interfere with the functioning of the onboard electronics. Failure to comply with
these rules will render the warranty null and void.
Note to the owner
This manual contains important information about the safe operation, adjustment, and maintenance of your tractor
loader. This manual is divided into chapters as outlined in the table of contents. Refer to the index at the end of this
manual for locating specific items about your machine. The tractor loader conforms to current safety regulations.
Use this manual as a guide. Your machine will remain a reliable working tool as long as it is kept in working condition
and serviced properly.
DO NOT operate or permit anyone to operate or service this machine until you or the other persons have read and
understand the safety, operation, and maintenance instructions in this manual. Use only trained operators who have
demonstrated the ability to operate and service this machine correctly and safely.
The information in this manual is provided on the basis of information that was available at the time that the manual
was written. Settings, procedures, part numbers, software, and other items can change. These changes can affect
the service that is given to the machine. Ensure that you have the complete and most current information from your
dealer before you start any machine operation.
The Operator's Manual is to be stored in the manual compartment equipped on this machine. Make sure this manual
is complete and in good condition. Consult your dealer to obtain additional manuals or manuals in other languages.
An Association of Equipment Manufacturers (AEM) safety booklet is included with each machine. Take the time to
read the booklet and understand its content.
Contact your dealer for any further information or assistance about your machine. Your dealer has Corporation ap-
proved service parts. Your dealer has technicians with special training that know the best methods of repair and
maintenance for your machine.
1-3