Case 1021F, Operator'S Manual

Page: 75 / 366

3 - CONTROLS AND INSTRUMENTS
Steering column [60628341]
Ignition switch
The ignition switch has four positions:
Accessory position
This position will energize the optional radio only. It will
not energize the instruments or start the engine.
OFF position
In this position, all switch controlled current is OFF. Turn
the key to OFF to stop the engine. Remove the key and
turn the Master Disconnect Switch to OFF.
START position
Turn the key to this position to engage the starter motor
to start the engine. The switch is spring loaded and will
return to the ON position when released.
ON position
This position will energize all electrical systems. The key
will return to this position after you release the key from
the start position.
RCPH10WHL114BAL
1
Horn and turn signal
WARNING
Hazard to bystanders!
Always sound the horn before starting the ma-
chine. Make sure the work area is clear of
other persons, domestic animals, tools, etc.
before you operate the machine. Never allow
anyone in the work area during machine oper-
ation.
Failure to comply could result in death or se-
rious injury.
W0304A
1. Horn - Push the horn lever in to actuate
the horn.
2. Turn signal lever - Push the control lever
up to signal a left turn. Pull the lever down
to signal a right turn. The lever must be
moved manually to the center position to
stop the signals.
RCPH10WHL115BAL
2
3-9