CASE CONSTRUCTION CX75C SR, Operator'S Manual

Page: 215 / 256

6 - MAINTENANCE
Bucket teeth
Bucket teeth removal
1. Place the bucket a few centimetres above the
ground. Stop the engine and remove the igni-
tion key.
2. Turn the locking stud 90 ° in the clockwise di-
rection using a hexagonal wrench.
3. Remove the locking pin then remove the worn
tooth tip.
SMIL13CEX2818AB
1
1. Clean the mating surface on the adaptor.
2. Engage a new tooth tip right up to the stop and
hold it in position.
3. Engage the locking pin until it is flush with the
tooth tip.
SMIL13CEX2819AB
2
4. Turn the locking stud 90 ° in the anti-clockwise
direction using a hexagonal wrench.
NOTE: when replacing a tooth tip, it is advisable to replace
the locking pin at the same time.
SMIL13CEX2818AB
3
6-69