CASE CONSTRUCTION CX75C SR, Operator'S Manual

Page: 179 / 256

6 - MAINTENANCE
Travel reduction unit oil
To check the travel reduction gears oil level, proceed
as follows:
1. Park the machine on flat, horizontal ground.
2. Move the machine so that plug (1) is in the
lowest possible position.
3. Stop the engine and remove the ignition key.
4. Slowly loosen the plug (3) to release any resid-
ual pressure.
5. Remove the plug (2) and check the oil level.
The level must come up to the bottom edge of
the port
(2) . If required, remove the plug (3)
and top up through this port until oil comes up
to the bottom edge of the port
(2) .
6. If necessary, replace the seals of plugs (2) and
(3) then replace the plugs.
7. Repeat the same operations for the other travel
reduction gear.
8. Travel slowly with the machine and make sure
there are no leaks.
SMIL13CEX2760AB
1
Hydraulic oil tank
WARNING
Burn hazard!
Before performing any service on the hy-
draulic system, you must allow it to cool.
Hydraulic fluid temperature should not
exceed 40 °C (104 °F).
Failure to comply could result in death or
serious injury.
W0241A
To drain the sediments and water from the hydraulic
oil tank proceed as follows:
•
Place a receptacle of a suitable capacity under
the drain plug.
•
Open the drain plug on the bottom of the tank
and drain the sediment and water accumulated
at the bottom of the tank.
•
After draining, close the drain plug.
•
Add hydraulic oil if necessary.
SMIL13CEX2761AB
1
6-33