CASE CONSTRUCTION CX75C SR, Operator'S Manual

Page: 163 / 256

6 - MAINTENANCE
Hydraulic oil level
WARNING
Burn hazard!
Before performing any service on the hy-
draulic system, you must allow it to cool.
Hydraulic fluid temperature should not
exceed 40 °C (104 °F).
Failure to comply could result in death or
serious injury.
W0241A
To check the hydraulic oil level proceed as follows:
1. Place the machine on flat, level ground and
place the attachment in the position shown.
Raise the dozer blade (if equipped). Stop the
engine and remove the ignition key.
SMIL13CEX2784AB
1
2. The oil should be in the middle of the indicator.
Add more oil if necessary.
SMIL13CEX2785AB
2
Filling the hydraulic tank
1. Release all pressure in the hydraulic reservoir.
Refer to page
6-11 .
2. Clean the cover plate and the area around the
plate. Remove the cover plate and add hy-
draulic fluid to the reservoir as required.
3. Replace the cover plate seal if required and
install the cover plate.
NOTICE: make sure that no contaminant (water, sand etc.)
enters the reservoir during filling.
SMIL13CEX2786AB
3
6-17