CASE CONSTRUCTION CX75C SR, Operator'S Manual

Page: 129 / 256

4 - OPERATING INSTRUCTIONS
Auxiliary hydraulic circuits
Consult your CASE CONSTRUCTION Dealer to select the optional accessory compatible with your machine and to
correctly adjust the flow required for its use.
NOTICE: to prevent failure or damage to the tool, make sure that you select the correct circuit configuration and flow
rate for the tool.
Hydraulic breaker or high flow hydraulic circuits (optional)
Your machine has two types of auxiliary hydraulic circuit. One circuit is for single flow equipment, such as hydraulic
breakers. The second type of circuit is intended for use with single flow or double flow with continuous flow or for use
with double flow such as demolition concrete crushers, etc.
1. Make the necessary tool connections and then, using
a hexagonal wrench, open the supply valves located
at the tip of the arm, left-hand and right-hand side.
SMIL13CEX2709AB
1
2. Switch (1) located on the front right-hand console,
corresponding to the hydraulic breaker. Each time
the switch
(1) is pressed, it switches between bucket,
breaker, and crusher.
SMIL13CEX2710AB
2
3. The icon of the accessory associated to each type of
flow is displayed on the screen.
NOTICE: in order to prevent breakdown of and damage to
the tool, always select the circuit configuration, flow, and
pressure that are correct for the tool.
SMIL13CEX2711AB
3
4-25