Case Communications Mayze 24, Reference Manual, Page: 99 / 166

6.2.6 and Appendix C. Attempts to continue dialling after the
limit is reached produce the message:
BLACKLIST
The blacklist is cleared by pressing the
DATA
button when the
modem is on-line. This also causes the modem to go off-line.
/ Dial Alternative Number
This modifier causes the modem to dial the specified alternative
number after a pause of 5 seconds if the first is unobtainable.
ATDnn / nnn
where
nn
is the first and
nnn
the alternative
number.
; Return to Command Mode after Dialling
The semicolon modifier is used at the end of a telephone number
so that you can issue more commands after dialling: for
example to enter a security code, or touch-tone commands to a
service. For example:
Terminal: ATDT9, 0123456789; Dial telephone no
Modem: OK
Terminal:
ATDT1234;
Transmit touch tones 1234
Modem: OK
Terminal: ATH Disconnect the phone call
In this example, the modem tone-dialled 9 to access an outside
line, paused, and then dialled 0123 456789. On completing
dialling, the modem responded with
OK . At this point the
modem was instructed to send a message 1234, which it sent
and returned
OK .
It is important to remember to terminate all message strings
with a semicolon. When your transaction has finished, you
must use the
H
command to clear the call.
DN Dial a Stored Number
This command is used to dial a number from the modem's
telephone directory.
DNn
where
n
selects location 0-50 in the directory.
The modem's configuration will be changed while dialling if the
location contained instructions to do so.
X460-306851 Issue 1 8-7 Rev.0