Case Communications Mayze 24, Reference Manual, Page: 83 / 166

6.3 Security Control
If dialback security has been set up (see Section 5.9), then you will need to
use the following procedure when dialling from a local modem to the
central site modem.
1. From your (calling) modem, dial the central site modem.
After the CONNECT message, you will see the prompt:
Enter Dial Back Password
2. Type your password, e.g. ABCDE . Do not insert a carriage return, just
wait.
The modem responds with:
Secure Dial Modem Dialling Back -
Replace Telephone Handset
*Re-dial if dialback is not received within 2 minutes*
Carry out these instructions.
3. The central site modem will now dial back using the stored number (e.g.
0123 456789).
After the incoming call is established, you will see the prompt:
Enter Dial Back Password
4. Type: ABCDE Do not insert a carriage return, just wait.
After 5-10 seconds you will receive the following message:
Secure Dial Modem - Software Issue NN/NN/X
where
NN/NN/X
is the command
I3
identification of the modem.
The link is now transparent and you can access the equipment attached to
the central site modem.
X460-306851 Issue 1 6-7 Rev.0