Case Communications Mayze 24, Reference Manual, Page: 128 / 166

S6 Dial Tone Wait Time
Timer Range: 4-8 (seconds) Default: 4 (seconds)
This register contains the time that the modem waits for a dial tone.
S7 Wait for Answer Tone
Timer Range: 5-40 (seconds) Default: 40 (seconds)
This register contains the time that the modem waits for a valid
carrier tone to be sent from the remote modem. The timeout
commences after the last digit is dialled. Not applicable in leased
line mode.
S8 Pause Time for Comma
Timer Range: 4-8 (seconds) Default: 4 (seconds)
This register contains the time that the modem waits when it
encounters a comma in an AT dialling sequence.
S9 DCD Detect Time
Timer Range: 0-255 (seconds) Default: 10 (seconds)
This register contains the time allowed to validate a connection.
S10 Carrier Loss to Hang-up Delay
Timer Range: 1-150 (each unit is 0.1 seconds)Default:25 (2.5
seconds)
This register contains the time that the modem waits, after the
carrier has been lost, before disconnecting the line (see *T). It is also
used by the
/A
command. Each count represents one tenth of a
second. The *B command can be used to change the units to 1.0
seconds.
S12 Escape Sequence Guard Time
Timer Range: 0-255 (in 0.2 seconds) Default: 50 (1 second)
The escape sequence guard time is the time required to elapse
immediately before and after sending the AT escape sequence
(default
+++
).
X460-306851 Issue 1 9-4 Rev.0