Case Communications Mayze 24, Reference Manual, Page: 119 / 166

*V V.25bis Command Mode
This command allows your modem to accept V.25bis commands.
(V.25bis commands are listed in Chapter 10.)
*V1
Modem accepts asynchronous V.25bis control.
*V2 Modem accepts byte synchronous V.25bis control.
*V3 Modem accepts HDLC synchronous V.25bis control.
The *V1 command can be entered through either the main DTE
port or the command port. It enables the port at which it is entered.
The
*V2
and
*V3
commands are only valid when commands are
entered at the main DTE port.
&W
Save User Configuration
This command allows you to store a newly customised
configuration from the active area.
&Wn where n is the user configuration number (0-3).
*W
DSR Control
*W0 Normal DSR control (see &C ).
*W1 DSR follows DTR. This is used for hosts which on
raising DTR expect DSR to be returned by the modem.
(Overridden by
/O
when in test mode.)
%W Stop Modifying the Remote Configuration
This command terminates the operation on the remote
configuration copy started by the
%Z
command. Subsequent
commands will affect the local modem's active configuration.
''W
Key Store
This command is used to store three alphanumeric characters as a
key (for use in conjunction with the Network 16 Controller Card for
authentication of level 2 security).
''Waaa where aaa is the key
See Section 5.9.
X460-306851 Issue 1 8-27 Rev.0