Case Communications Mayze 24, Reference Manual, Page: 114 / 166

&Q13 Asynchronous mode. When DTR goes low the modem
disconnects and puts the busy-out condition on the line.
&Q14
Synchronous mode. When DTR goes low the modem
disconnects and puts the busy-out condition on the line.
%R RTS/CTS Control
This command allows you to control the state of CTS from your
modem.
%R0 CTS follows RTS when on-line.
%R1 CTS is always on when the modem is off-line, and
follows RTS when on-line. This enables you to
configure your modem and dial out. Default.
%R2 CTS is on in command mode.
%R3 CTS is always on. This is used in full-duplex operation,
where the state of CTS must be high to allow the
terminal to communicate with the modem.
''R Manual Retrain
This command will cause the modem to initiate a retrain to
synchronise with the remote modem. For V.22bis and V.22 modes
only. This is usually used only for test purposes.
Sn?
Display Single S-Register Setting
This command will display the setting of a single S-register where
n is the S-register location to be examined.
The &O command selects the format for this display.
Sn=
Set an S-Register to a Value
This command will set an S-register content to a new value.
Sn=xxx where n is the S-register location and xxx is the new
value in decimal (prefix it with > for hexadecimal).
&S Front Panel Switch Control
This command allows you to disable the front panel switches and
re-program the
AL
button to perform different functions.
&S0 Front panel switches disabled.
X460-306851 Issue 1 8-22 Rev.0