Case Communications Mayze 24, Reference Manual, Page: 107 / 166

flow control characters are stored in registers S41 (secondary XON)
and S42 (secondary XOFF). See Section 5.6.
&L Line Type
This command is used to set your modem from default PSTN to
leased line operation (for leased line operation see the Appendix
entitled 'Technical Guide').
&L0
Enable 2-wire PSTN operation. Default.
&L1 Enable 2-wire leased line operation.
When you select leased line operation, the modem goes on-line in
the mode determined by the
''A command. See Section 5.5.
M Speaker Control
This command controls your standalone modem's internal speaker.
M0 Speaker off.
M1 Speaker on during call set-up and off when
carrier is detected.
M2 Speaker on.
M3 Speaker on during call set-up. It is off when carrier is
detected and when dialling. Default.
*M Inactivity Data Monitor
This command controls a disconnect timer that will clear the call if
the modem has not seen any data for a period of time.
*M0
Data monitor disabled. Default.
*M1 Transmitted data (from DTE) is monitored.
*M2 Received data (from line) is monitored.
*M3
Both transmitted data and received data are
monitored.
The length of monitoring time is stored in S-register S37, which can
be set between 0 and 255 minutes.
Nn?
Display a Single Directory Entry
This command is used to display a single entry from the modem's
directory where
n represents the entry (0-50) that you want to
display.
X460-306851 Issue 1 8-15 Rev.0