OWNER’S MANUAL
SYSTEM OPERATING INFORMATION
86
7
3237 • X6 02/2018
Shore Power Connection
To minimize shock and fire hazard:
• Before using the shore power cord, examine
the cable for damage. Never use the shore
power cord if it appears cut or damaged.
• Turn off the yacht’s shore connection switch
before connecting or disconnecting the cord.
• Connect the shore power cord to the craft’s
inlet before connecting to the shore power
source.
• If the yacht is equipped with a polarity
indicator that activates, disconnect the shore
power cord and correct the polarity.
• Disconnect the shore power cord at the
shore outlet first.
• Never leave the shore power cord connected
to the shore outlet when the cord is not in
use.
• Close the shore power inlet cover tightly.
• If the reverse polarity indicator light is
activated, do not use the electrical system.
Correct the polarity fault before activating the
electrical system on the craft.
• Never alter the plug and connector on the
shore power cord.
WARNING
!
Switching off the ELCI circuit breaker groups before
connecting to the shore power prevents arching
and burning of the shore power cord receptacles.
Disconnecting will protect the electrical equipment on
board from rapid ON/OFF current connections, which may
occur during the connection process.
NOTICE
1 ]
Switch OFF the WATER HEATER circuit breaker on
the AC control center. Never switch the breaker ON
again until the freshwater system has been filled,
pressurized and primed.
Water Heater
Circuit Breaker
Figure 7-10
2 ]
Switch OFF the ELCI circuit breaker group(s).
Depending on region that the yacht is shipped to,
the ELCI are labeled either:
• LINE 1/LINE 2
• SHORE 1/SHORE 2
C34_Coupe.indb 86
2/8/2018 3:42:30 PM
