Trouble shooting
40
Version; 1.3
o
Reset XPORT to defaults
o
Turn off the USG
o
Put all the DIP switch in the "on" position
o
Turn on the USG.
o
Wait one minute.
o
Turn off the USG
o
Turn the DIP switches off again,
o
power the USG on
o
Try to connect to DeviceInstaller again. If this time the connection
is established, use the Web Configuration (select the web
configuration tab in the device installer application) to configure
lancusrouter’s host and continue from start.
Figure 19: lancusrouter configuration
If still the USG does not connect the installation with this
device failed. Contact CartaSense for further support
B.4.2:
Network connectivity
Assuming the USG is connected to the DeviceInstaller the following should be
validated.
B.4.3:
DHCP
