35
CARSON Mini Tyrann Pro 260 • 50 050 7038
GB
Trimming the helicopter
Already shortly before the helicopter takes off, you can recognize
whether it wants to turn or glide in a particular direction.
Correct the deviations from the vertical ascent with the trim slider of
the tail rotor function.
Tip of the fuselage turns to the right:
• Reduce speed and push the trim slider of the tail rotor function on
the remote control lever stepwise to the left.
• Push the throttle lever forward again and check whether the
correction was sufficient, if necessary shift the trim further to the
left.
• Repeat the process until the helicopter no longer shows a
tendency to turn to the right.
Tip of the fuselage turns to the left:
• Proceed as described above, but push the trim slider of the tail
function stepwise to the right.
Model slips (drifts) or tilts to the right:
• Reduce the speed and push the trim slider of the roll-function of
the right remote control lever stepwise to the left.
• Push the throttle lever forward again and check whether the
correction was sufficient, if necessary shift the trim further to the
left.
• Repeat the process until the helicopter no longer shows a
tendency to drift to the right.
Model slips (drifts) or
tilts to the right:
• Proceed as described above, but
push the trim slider of the tail
function stepwise to the right.
Model slips (drifts) forward:
• Reduce the speed and push the trim slider of the nick function on
the right remote control lever stepwise backwards.
• Push the pitch lever forward again and check whether this was
sufficient for correction, if necessary shift the trim further to the
left.
• Repeat the process until the helicopter no longer shows a
tendency to drift forwards.
Model slips (drifts) backwards:
• Proceed as described above, but
push the trim slider of the nick
function stepwise forward.
n. Flight Operation
Check the effective range of the remote control
transmitter
Before every first start or after a crash, check the function and
effective range of the RC equipment! In the neutral position of the
control lever of nick and roll, the swash plate should also be in
neutral position.
If this is not the case, correct the position with the trim levers of the
respective control channel on the transmitter.
• Move slowly away from the model (motor is not running!).
• Consecutively press the remote control levers nick and roll and
• Observe the reactions of the model.
The RC equipment works faultlessly if from about 30 m distance
the model still correctly responds to the remote control signals. The
maximum range of the transmitter is about 100 m.
Never drive the model if the remote control does not work properly!
A malfunction of the radio may cause damage to the model, property
and/or serious injury.
If the remote control should fail to function perfectly, first check the
state of charge of the transmitter and receiver batteries and make sure
that no one else is transmitting on your frequency.
