Safety instructions
Please read the operating instructions before using the unit for
the first time.
Only use the unit in enclosed spaces.
pay attention to the connector force, do
not apply power.
• Once this is fully charged, the charger will change to pulsating
trickle charging, and the LED1 will turn green.
• If the red LED flashes in quick succession, this indicates a
defect. In this case, disconnect the power plug and remove
Only for NiMH batteries.
the battery pack from the charger unit.
Never attempt to recharge dry batteries.
Ensure that the battery’s capacity matches the charging current
Disposal
of the unit.
Keep small children away from the unit while charging.
Please note and understand the symbols on this
Children should only operate the charger unit if supervised by an
product, packaging or instructions. Electronic
adult.
components are valuable materials and at the end of
Allow heated batteries to cool prior to charging.
their useful life should not be disposed with
If a battery becomes very hot (>40°C, battery poss. defective),
household waste! Help us to protect the
disconnect the power plug.
environment and safeguard our resources by
Never use the charger as a direct current supplier for electrical
discarding this equipment at a dedicated recycling
appliances.
point. The authority responsible for waste disposal
or your retailer will be able to answer any questions
you may have in this respect.
Rechargeable battery types
Racing pack 7,2Volt (1,2Vx6 cells, NiMH)
Caution
Transmitter battery/ies 4.8Volt (1,2Vx4 cells, NiMH)
• For use indoor only.
• Disconnect the supply before making or breaking connections
Charging process
to the battery,
Insert the power plug of the charger into a standard domestic
• If the supply cord is damaged, it must be replaced by the
socket outlet. Connect the plug for charging the racing pack (6
manufacturer, its service agent or similarly qualified persons in
cells) to the charger plug,
order to avoid a hazard,
• Do not disassemble charger, incorrect reassemble may result
Insert the plug for charging the transmitter battery/ies (4 cells)
in electric shock or fire. - Locate charger as far away from
into the charging socket of the transmitter.
battery as DC cable permit Never place charger above battery
The charging of both battery types can occur either individually or
being charged, gases from battery will corrode and damage
simultaneously.
charger.
• These chargers are not intended for use by persons (including
During the charging process, the charger unit will heat up slightly
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
• When charging the transmitter batteries (4 cells), the red
given supervision or instruction concerning use of the
LED2 will light up.
appliance by a person responsible for their safety.
• Once these are fully charged (batteries are getting warm),
• Children should be supervised to ensure that they do not play
remove the charger plug from the transmitter.
with the charger.
• When charging the racing pack (6 cells), the red LED1 will
light up.
Charger unit art. nr. 50 060 6046
For charging transmitter and racing batteries
LED1 Racing Pack
LED2 Transmitter
battery / ies
Charging jack for transmitter (4.8V)
(Tamiya-)
Charging plug
for Racing Pack 7,2V
Polarity of charging jack
Specifications
Input voltage
AC voltage 230V 50Hz 38 W (max)
60mA max => 14W
without load
Output voltage 1
13.1V +/- 15%
without load
Output voltage 2
8.5V +/- 15%
without load
Output current 1
2A +/- 10%
at output for 7.2V DC voltage
Output current 2
0.2A +/- 25%
at output for 4.8V DC voltage
Delta-peak cutoff
140mV max
Cutoff via timer
3hrs
+/- 30 minutes with 6-cell battery pack
Shorting fuse
automatic
with short circuit at output
Trickle current
130mA max
mean value pulse charging 6 cells
Fuse
Current strength 1.6A
Service-Hotline:
(8.00 Uhr -17.00 Uhr)
(01805) 73 33 00
14 ct/min
Dickie-Tamiya GmbH & Co KG
Mittlere Motsch Str. 9
96515 Sonneberg
