Carrier TruVu UCXP683T-V, Installation And Startup Manual

Page: 72 / 76

Appendix - Module Status field descriptions
TruVu™ UCXP683T -V CARRIER CORPORATION ©2021
Installation and Start-up Guide All rights reserved
68
Field Description
ADDRESS BINDING The controller's:
•
Device Instance
•
Network number
•
MAC address
See To set up the controller through the Service Port (page 48).
Date/Time Date and time the Modstat was run
Model Name Identifies the Product Type
Device Instance A unique ID assigned to the controller
Driver built When the driver was built
Downloaded by When and where the last download was performed
Application Software Version The application software version that is in the BACnet device.
Data Partition Version Not applicable to this device.
# PRGs initialized
# PRGs running
If applicable, the number of control programs that were downloaded vs. the
number that are running. If these numbers are not the same, the controller
has a problem such as lack of memory.
Driver version The name, version, and date of the driver, as well as all the bundles and
versions.
Reset Counters: The number of times each of the following events have occurred since the last
time the controller was commanded to clear the reset counters.
See
NOTE below this table.
Power failures Interruption of incoming power
Commanded boots Includes commands issued from the i-Vu® interface such as the zap manual
command, plus commands issued during a memory download.
System errors Error in the controller's firmware or hardware
S/W Watchdog
timeouts Watchdog is firmware that monitors the application firmware for normal
operation. If the watchdog firmware detects a problem, it restarts the
application firmware.
H/W Watchdog
timeouts
H/W Watchdog will restart the controller if it detects a severe problem with the
controller's operating system
System status Gives the current status of the controller's operation. See LEDs (page 58) for
all possible conditions.
Network status Gives the current status of the controller's networks. See LEDs (page 58) for
all possible conditions.
System error message history High-severity errors since the last memory download. Shows the most recent
10 messages.
See NOTE below this table.
Appendix - Module Status field descriptions