Carrier TruVu TV-MPCXP1628-NR, Installation And Startup Manual

Page: 79 / 94

Troubleshooting
TruVu™ MPC Controller ( part no. TV-MPCXP1628-NR) CARRIER CORPORATION ©2021
Installation and Start-up Guide All rights reserved
73
To configure custom Prog 1/2 LEDs
You can customize the Prog 1 and/or Prog 2 LED for site-specific purposes by configuring the BACnet Analog
Output (BAO) microblock.
In the i-Vu® interface, select the TV-MPCXP1628-NR on the navigation tree, and on the Properties page > I/O
Points tab, under Hardware Configuration , set the following:
Status/Attribute Microblock
type
Expander number :
Channel number
I/O type Description
LED 1 BAO 0:61 Special •
<=0 Normal
•
>15 On
The number of blinks equals the
Present Value.
The pulse pattern repeats after a
2-second delay
LED will blink the number of times
given in the BAO with ON pulse
0.5 seconds and OFF pulse 0.5
seconds.
LED 2 BAO 0:62 Special •
<=0 Normal
•
>15 On
The number of blinks equals the
Present Value.
The pulse pattern repeats after a
2-second delay
LED will blink the number of times
given in the BAO with ON pulse
0.5 seconds and OFF pulse 0.5
seconds.
To get a Module Status report
A Module Status report provides information about the controller and verifies proper network communication with
the controller. You can get this report:
•
In the i-Vu® application — Right-click the controller on the navigation tree, then select Module Status .
•
On the controller setup ModStat tab — See To set up the controller through the Service Port (page 61).
See Appendix - Module Status field descriptions (page 81).