Carrier i-Vu XT, Installation And Startup Manual

Page: 16 / 50

i-Vu® XT Router (drv_gen5) CARRIER CORPORATION ©2022
Installation and Start-up Guide 13 All rights reserved
To set an IPv6 address
You must define the i-Vu® XT Router's IPv6 addressing (IPv6 address, multicast address, and default gateway) in
the Service Port controller setup pages so that the router can communicate with the i-Vu Pro Server on the IP
network.
Use one of the IPv6 addressing schemes described below with the instructions that follow below.
Use a... If...
Default IP Address
that your system creates
fd01::192:168:168:<rotary>
Custom Static
from your network administrator
Select Custom Static if you have a permanent IP addresses which
does not change and is usually obtained from the network
administrator.
DHCP
generated by a DHCP server
The IP network uses a DHCP server for IP addressing
Link-Local
This is an autogenerated private IP address used for local network
segment communications. Segment starts with FE80.
SLAAC Used for Global Scope addressing and multicasting. This is defined
by the building network administrator. Segment starts with FCxx or
FDxx.
NOTE Carefully plan your addressing scheme to avoid duplicating addresses. If third-party devices are integrated
into the system, make sure your addresses do not conflict with their addresses.
To set a custom IP address
1
Obtain the IP address, subnet mask, and default gateway address for the router from the facility network
administrator.
2
On the Connections page, under the Gig-E Port tab > BACnet/IPv6 , select Custom Static in the drop-down list
for Address Mode .
3
Enter the IP Address , Prefix Length , and Default Gateway addresses that the network administrator gave
you.
4
Click .