4
32802000301
Specifications subject to change without notice.
BUTTON FUNCTIONS
Before you begin using your new air conditioner, make sure to
familiarize yourself with the remote control. The following is a brief
introduction to the remote control.
Fig. 3
-
Remote Controller Buttons
1. ON/OFF Button (
)
This button turns the unit ON and OFF.
2. UP Button (
) and DOWN Button (
)
Press these buttons to increase or decrease the set temperature or
Timer setting hours.
3. Fan Button (
)
Used to select the fan speed in four steps:
NOTE:
Hold down this button for at least 2 seconds to activate/cancel
Silent mode. Due to low frequency operation of the compressor,
it may result in insufficient cooling and heating capacity.
4. Fan Button (
)
Used to select the fan speed in four steps:
You cannot switch the fan speed in AUTO or DRY mode.
NOTE: Hold down this button for at least 2 seconds to activate/cancel
Turbo mode. Turbo function enables the unit to reach the preset
temperature at cooling or heating operation in the shortest time. If the
indoor unit does not support this function, there is no corresponding
operation happening when this button is pressed.
5. Swing Button (
)
Used to stop or start horizontal louver movement. Hold down this
button for 2 seconds to start/stop vertical louver movement. Not
available on this system.
6. Set Button
Used to initiate the following functions in the sequence below, in
conjunction with the
and
buttons.
(* Indicates optional functions)
Press the SET button to select the desired function. The selected
symbol will flash on the display area. Then press the
or
button to confirm.
SLEEP Function (
)
This function maintains the most comfortable temperature and
saves energy. It is available in COOL, HEAT, or AUTO modes
only.
For details, see sleep operation in the USERS MANUAL.
* FRESH Function (
)
Not available on this system.
* SELF CLEAN Function (
) (optional)
In SELF CLEAN mode, the unit automatically cleans and dries
the Evaporator and keeps it fresh for the next operation.
* FOLLOW ME Function (
) (optional)
When the Follow Me function is activated, the remote display is
the actual temperature at its location. The remote control will
send this signal to the unit every 3 minutes until the FOLLOW
ME button is pressed again.
7. Shortcut Button
S
Used to restore the current settings or resume previous
settings.
S
The first time connecting to power, if the SHORTCUT button
is pressed, the unit will operate in AUTO mode, 80
°
F, and
the fan speed is Auto.
S
Push this button when the remote controller is on, and the
system automatically reverts back to the previous settings
including operating mode, setting temperature, fan speed
level, and sleep feature (if activated).
S
If this button is pressed more than 2 seconds, the system
automatically restores the current operation settings including
operating mode, setting temperature, fan speed level, and
sleep feature (if activated).
8. Mode Button
Press this button to modify the unit mode in the following
sequence:
9. LED Button (
)
Press this button to turn ON/OFF the indoor screen display.
NOTE: Pressing and holding the LED and SWING buttons together
for 3 seconds will alternate the temperature display between
°
C and
°
F
scales.
10. LOCK Function
Press SHORT CUT and LED buttons together to lock or unlock
the keyboard.