808-970
Rev. 6/00
TeLINK Installation Instructions
Installation
TeLINK is a device designed to allow a CCN to communicate with another CCN over a tele-
phone network. The device establishes this CCN to CCN link through modems.
Install the Modem
1.
Insert the factory- or field-supplied PCMCIA Type II modem card into the back of the
TeLINK enclosure (refer to Figure 1).
Connectors
Figure 1 indicates the connectors that are used to provide power to the TeLINK, and to connect it
to the CCN.
Make these connections in the following order:
2.
Connect an RJ-11 modular telephone jack to the modem card.
3.
Connect a factory- or field-supplied unregulated 9 Vac power supply to the 0.1" (2.5 mm)
power jack.
4.
Connect the primary CCN Communication Bus to the factory-supplied, three-pin screw
terminal-type CCN Bus connector. Consult the CCN Installation and Start-up Manual
(808-211) for information concerning the wiring that must be provided for that purpose.
Optional
5.
For your convenience, the RJ-11 telephone jack can be connected from the front of the
TeLINK enclosure to the Network Service Tool (refer to Figure 2) .
Figure 1
Back View
Page 1 of 2
