CarpeStar CUMG Series, User Manual

Page: 25 / 38

See Figure 3-17 for the Management Parameters Setting interface. The table below explains the
items shown in the above figure.
Item Description
WEB Port The port which is used to access the gateway via WEB. The default value is 80.
Access Setting
Sets the IP addresses which can access the gateway via WEB. By default, all IPs
are allowed. You can set an IP whitelist to allow all the IPs within it to access the
gateway freely. Also you can set an IP blacklist to forbid all the IPs within it to access
the gateway.
Time to Log Out
The gateway will log out automatically if it is not operated during a time longer than
the value of this item, calculated by s, with the default value of 1800ms.
SSH
Sets whether to enable the gateway to be accessed via SSH, with the default value
of
No
.
SSH Port The port which is used to access the gateway via SSH.
Remote Data
Capture
After this feature is enabled, you can obtain the gateway data via a remote capture
tool. The default value is
No
.
Capture RTP
Sets whether to capture RTP. Once this feature is enabled, the RTP package will
also be captured by the selected network.
FTP Sets whether to enable the FTP server, with the default value of
Yes
.
SYSLOG
Sets whether to enable SYSLOG. It is required to fill in SYSLOG Server Address
and SYSLOG Level in case SYSLOG is enabled. By default, SYSLOG is disabled.
Server Address Sets the SYSLOG server address for log reception.
SYSLOG Level Sets the SYSLOG level. There are three options:
ERROR
,
WARNING
and
INFO
.
Monitor
Self-adaption
Enable the NAT stun between the gateway and the monitor tool. By default, it is
disabled.
Monitoring LAN Port Sets the LAN port for the monitoring.
NAT Traversal,
Traversal
Type
Sets whether to enable the NAT traversal. By default this feature is disabled. There
is only one traversal type:
Port Mapping
.
LAN1 Mapping
Address,
LAN2 Mapping
Address
The mapping addresses of LAN1 and LAN2 in case the NAT traversal is enabled. If
the port mapping is selected as the traversal type, you are required to set the
mapping address on the router and fill in the corresponding information here as well.
By default, only the IP address need be filled in, and the port value is just the same
as the SIP signaling port.
NTP
Sets whether to enable the NTP time synchronization feature. It is required to fill in
NTP Server Address , Synchronizing Cycle and Time Zone in case NTP is
enabled. By default, NTP is disabled.
NTP Server Address Sets the Server address for NTP time synchronization.
Synchronizing Cycle Sets the cycle for NTP time synchronization.
Daily Restart
Sets whether to restart the gateway regularly every day at the preset Restart Time .
By default, this feature is disabled.
Restart Time Sets the time to restart the gateway regularly.
System Time
The system time. Check the checkbox before Modify and change the time in the edit
box.
C
UMG Gateway User Manual (Version 1.6.3)
Page 20