Carpenter MFG 59, Operator'S Manual

Page: 20 / 22

Carpenter Model 59 Wire Prefeed & Dereeler
Carpenter Model 59 Wire Prefeed & Dereeler
•
Phone : (315) 682-
9176 •
Fax : (315) 682-9160
Website
: www.carpentermfg.com •
Email : wire@carpentermfg.com
Revised 09/27/2021 Page 20
Section 5
–
Recommended Spare Parts and Optional
Accessories
The below items are recommended spare parts for the Model 59.
Quantity Per Machine Carpenter Part Number Description
1 8447 Feed Belt Pair
The below items are optional accessories for the Model 59.
Carpenter Part Number Description
5266 Input Roller Guide Assembly
5521 2.5-Pound Pulley Weight
8989 Prefeed Stop Interface Cable
Input Roller Guide Assembly
If the material spool is not mounted to the PN 5269 dereeler stand assembly as outlined
in “
Section 1
– Assembling the Model 59 ”, use of the optional PN 5266 input roller guide
assembly may be necessary. If material is pulled from a wire rack or from a floor-mount
dereeler, the PN 5266 input roller guide assembly helps ensure material feeds correctly
into the Model 59.
Follow the steps below to install the PN 5266 input roller guide assembly onto the PN
5269 dereeler stand assembly. Refer to Figure 14 below for a properly assembled PN
5266 input roller guide assembly.
1. Remove the (2) PN 2509 cap screws and (2) PN 6510 washers included with the
PN 5266 input roller guide assembly.
2. Line up the mounting holes on the PN 5266 input roller guide assembly with the
mounting holes on the Model 59 cabinet. Refer to Figure 2 above.
3.
Using a 3/16” hex wrench, install the PN 5266 input roller guide assembly with
the included (2) PN 2509 cap screws and (2) PN 6510 washers.